Kikyō
A pendant of five deep lobes on a gentle barrel, like a balloon flower about to open.
From RM329.00
Pendant Lights
Printed light, hung.
Printed to order.
Four patterns on four shapes.
A ceiling rose, or Wa's three cables.
Bulb or LED strip included.
Get the highlights.
Day and night.
By day it is a printed object in the colours you chose. Switch it on, and the shade becomes the light.
Made to come apart.
Taken apart · Kikyō
One printed piece.
The shade is printed whole, with the ring that holds the lampholder built into it. Nothing over your table is held together by a joint.
1 printed piece E27 ring printed in
0
magnets overhead
3
sizes for most designs
4
patterns
2700 K
LED light included
Kikyō
A pendant of five deep lobes on a gentle barrel, like a balloon flower about to open.
From RM329.00
Tsurigane
A temple-bell pendant: sixteen broad flutes turned through 20 degrees, flaring to a lip at the hem.
From RM329.00
Yunomi
A tall tea-cup pendant whose forty ribs spiral through 70 degrees as they rise.
From RM329.00
Shigure
A waisted cone of fine ribs that sway like a passing shower, hardest at the hem.
From RM329.00
Hamon
A stepped cone named for ripples on water: one terrace winds from the wide rim up to the neck.
From RM329.00
Hachi
A bowl on a beaded collar, with a faceted prow rising up one side.
From RM329.00
Wa
Wa, the ring: a level hoop of glowing arcs, lit along its underside and hung from the ceiling on three cables.
From RM1,990.00
Gourd
Two bulbs over a trumpet mouth, under fine ribs.
From RM329.00
UFO
A short tube over a flying-saucer disc, under fine ribs.
From RM329.00
Stack
Two stacked discs over a flared mouth.
From RM329.00
Bar
A low, cross-shaped sleeve with upright walls.
From RM329.00
Tiers
A cup, a bowl, a domed saucer and a cylinder, stacked in tiers.
From RM329.00
Hourglass
An hourglass under a flat cap.
From RM329.00
Hex
A long six-sided lantern.
From RM329.00
Pear
A fluted teardrop circled by bands.
From RM329.00
Bottle
A narrow neck over a fluted cone, with a faceted band.
From RM329.00
Spool
A flared cap over an hourglass, like a spool of thread.
From RM329.00
Lattice
An egg crossed by raised courses and meridians, like a lattice.
From RM329.00
Slant
A long teardrop whose mouth is cut on a slant.
From RM329.00
Egg
A plain egg, open below.
From RM329.00
Pleat
A tall bell of V-shaped pleats that deepen towards the rim.
From RM329.00
Icicle
A tapering tube, crumpled and twisted towards its tip.
From RM329.00
Leaf
A spindle of four ridges turned through half a turn.
From RM329.00
Blade
A flat elliptical blade with a quarter turn of twist.
From RM329.00
Hat
A wavy cone of a brim, low over the bulb.
From RM329.00
Terrace
A low oval dish whose underside steps in to the centre in terraces, open at the top on four spokes.
From RM329.00
Bell
A bell of upright fins.
From RM329.00
Cone
A cone of swaying ribs.
From RM329.00
Cup
A ribbed cup, its ribs set a little off vertical.
From RM329.00
Scallop
Eight scalloped lobes with a hammered surface.
From RM329.00
Lozenge
A capsule of light under a small navy cone cap.
From RM329.00
Bamboo
A straight column in three lengths, each node a sharp ridge between flared ends.
From RM329.00
Trumpet
A matte horn sweeping out from a slim neck to a wide mouth; the light falls from below.
From RM329.00
Drop
A round onion of light drawing up to a point under a small black cap.
From RM329.00
Handbell
A matte grey bell on a slim neck; the light falls from below.
From RM329.00
Drum
A soft pillow of light under a small navy cone cap.
From RM329.00
Dome
A stepped bowl of light under a red dome hat, a gap of light between them.
From RM329.00
Cupola
A low dome of light under a black cup.
From RM329.00
Cocoon
A plain egg of light under a small grey cone cap.
From RM329.00
Spinner
A terracotta spinning top: a wide cone hat over a body drawing to its mouth, the light spilling out between them.
From RM329.00
Clam
A cone of light between two leaning red discs, like a clam half open.
From RM329.00
Compare.
| Small | Medium | Large | Wa | |
|---|---|---|---|---|
| Designs | 40 shapes | 40 shapes | 40 shapes | A ring, two widths |
| Size | Ø7–17.9 × H6–22.4 cm | Ø8.8–22.4 × H7.5–28 cm | Ø10.6–24.8 × H9–33.6 cm | Ø80–120 × H10–11.4 cm |
| Price | RM329.00 | RM399.00 | RM499.00 | From RM1,990.00 |
| Bulb | LED G45 E27, 2700 K, included | LED A60 E27, 2700 K, included | LED A60 E27, 2700 K, included | 24 V LED strip, 2700 K, plug-in adaptor included |
| Colours | Three glowing | Three glowing | Three glowing | Arcs: three glowing. Blocks: three solid |
| Assembly | One printed piece, no magnets | One printed piece, no magnets | One printed piece, no magnets | Printed arcs and blocks on an aluminium hoop, no magnets |
| Cord | E27 holder, 2 m twisted fabric cord, ceiling rose | E27 holder, 2 m twisted fabric cord, ceiling rose | E27 holder, 2 m twisted fabric cord, ceiling rose | Three steel cables to a ceiling canopy |
Accessories.
Sold singly
A part in another colour
Every part lifts off its magnets, so a new shade, top or base changes the lamp without replacing it. Each one is sold on its own, in any colour.
Materials Guide.
Every lamp is printed to order, one fine layer at a time, entirely in PLA.
- Translucent PLA
- The parts that glow - shades, orbs, diffusers. Printed as two walls, 0.84 mm together, so the light comes through the material itself. Colour changes the light as much as the look: light colours fill a room, darker ones glow more quietly.
- Matte PLA
- Bases, backplates, rings, bands, caps, tops, collars and feet. Opaque, printed thicker, in the colours that frame the glow.
- PLA
- Printed entirely in PLA, a plastic made from plant sugars - from crops such as corn - instead of oil.
- Layer lines
- Faint lines one layer apart run round every printed part. They are how the lamp was made, and lit, they are part of the picture.
- Heat
- Use LED bulbs only - every lamp comes with one - never incandescent or halogen, which run far hotter than a printed lamp is made for. Keep the lamp out of hot direct sun.
- Care
- Indoor use. Dust with a dry cloth or a soft brush; keep solvents and harsh cleaners away from the printed parts.
- Colour
- Tint can vary slightly between spools. For lamps that must match, order them together.
Pendant Lights
The one that hangs over the table.
A printed shell on a twisted fabric cord. Kikyō, Tsurigane, Yunomi and Shigure each come in four surfaces: original, bubble, wave and knit.
See the range
Coming soon, from RM329.00 complete
No magnets
Nothing held over your table by magnets
Each pendant on a cord set prints as a single shell with its E27 ring at the top. The lampholder clamps the ring and the bulb hangs inside - nothing to assemble. Wa's arcs are threaded on an aluminium hoop.
4 patterns
The same shape, a different surface
Kikyō, Tsurigane, Yunomi and Shigure come in original, bubble, wave or knit, picked on the page and printed for you.
2 m
Twisted fabric flex, shortened to your ceiling
The cord set arrives at 2 m with the ceiling rose and the lampholder fitted. Shorten it to the drop you want - about 750 mm above a table top is the usual answer.
LED only
Where the bulb matters most
Heat rises, and a pendant on a cord set hangs directly over its bulb, so it sits in its own rising heat. A 6 W LED runs far cooler than any other bulb, and the LED in the box is the reason it lasts. Never improvise a bulb for it.
Light where people sit.
Printed to order in Malaysia, one at a time, in a wall two beads thick.
What is in the box.
Everything needed to hang it: the shade, the cord set made up, and the bulb it was designed around.
- Shade
- One piece of translucent PLA, its top ring clamped by the lampholder. Three sizes; four designs also in four patterns.
- Cord set
- The same E27 lampholder and 2 m twisted fabric cord as every lamp, with a ceiling rose.
- Bulb
- 2700 K LED: a G45 golf ball in the small size, an A60 in medium and large.
- Wa
- The exception: translucent PLA arcs and matte PLA joint blocks threaded on an aluminium hoop, in two sizes, lit by a 24 V LED strip, with a plug-in adaptor and dimmer, a ceiling canopy and three steel cables.
- Colours
- Every part in its own colour, chosen on the page. Light colours pass more light; dark ones less.
- Made
- To order, in Malaysia. Ships by Fri 23 Oct.
Before you buy A pendant on a cord set replaces the fitting at an existing ceiling point, which is electrical work. If you would not change a light fitting yourself, have an electrician hang it - it is a fifteen-minute job for one. Wa, the ring, plugs into a socket instead.
If you are not sure
The same answers the product page gives, so nothing changes between here and checkout.
What it is made of
Translucent where the lamp glows, matte for the trim, printed one fine layer at a time. Printed entirely in PLA, a plastic made from plant sugars - from crops such as corn - instead of oil.
Each spool varies very slightly in tint, so two lamps bought months apart may not be an exact colour match. For lamps that must match, order them together.
Which bulb, and why it matters
LED only, 6 W or less, and this one is not a preference.
Never an incandescent or halogen bulb: inside a closed shade it runs far hotter than a printed lamp is made for. A 6 W LED runs far cooler, which is why only LEDs are allowed. Every lamp ships with its LED.
2700 K is the warm white these are rendered and finished against. Keep the lamp out of hot direct sun as well.